Logo

U2817 Engine Code Repair

Meaning of U2817 engine trouble code is a kind of network trouble code and when the check engine light comes U2817 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

U2817 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U2817 code is occuring now you should check U2817 repair processes.
Now don't ask yourself; What should you do with U2817 code ?
The solution is here :

U2817 Possible Solution:

U2817 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

U2817 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

2
Fuel And Air Metering (Injector Circuit Malfunctions Only)

8
Fuel Rail Pressure Sensor Circuit Malfunction

1
Cold Start Injector 1 Malfunction

7
Ignition Coil A Primary/Secondary Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U2817 OBD-II Diagnostic Network (U) Trouble Code Description

U2817 engine trouble code is about Ignition Coil A Primary/Secondary Circuit Malfunction.

Main reason For U2817 Code

The reason of U2817 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

U2817 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.